User's Manual

Figure 9-25 Elevator Control
2. Check t
o enable elevator control funcon.
3. Select an Elevator No., and select an elevator controller type for the elevator.
4. Select Interface Type.
Note
If you select In
terface Type as RS-485, you only need to enter Negave Floor
Capacity.
5. En
ter Negave Floor Capacity, and select Alarm Receiver Type.
6. Enter the elevator controller's Server IP Address, Port No., User Name, and
Password.
7. Click Save to enable the sengs.
Video Intercom Face Recognion Door Staon User Manual
74