User's Manual

Nofy Surveillance Center
Send an excepon or alarm signal to the remote management soware
when an event occurs.
7.
Click Sa
ve to enable the sengs.
Set Video Tampering Alarm
When the congured area is covered and cannot be monitored normally, the alarm
is trig
gered and the device takes certain alarm response acons.
Steps
1.
Click Event → Basic Event → Video Tampering to enter the sengs page.
2.
Check Enable Video T
ampering.
3.
Draw area.
1) Click Area Sengs.
2)
Click
, and drag the mouse in the live view page to draw an area.
3)
Oponal: Click to clear the drawing area.
4.
Dr
ag the block to set the Sensivity. The higher the value is, the easier to detect
the ar
ea covering.
5.
Oponal: Click Link
age Method, and check the normal linkage or nofy
surveillance center according to your actual needs.
Normal Link
age
Set the normal alarm linkage.
Nofy Surveillance Center
The alarm informaon is uploaded to the surveillance center when an alarm
event is detected.
6.
Oponal: Click
or to perform the record or capture operaon.
7.
Click Sa
ve to save the sengs.
Event Linkage
Steps
1.
Click E
vent → Basic Event → Event Linkage to enter the sengs page.
Video Intercom D Series Door Staon User Manual
46