User's Manual

Chapter 6 Local Sengs
6.1 Add Administrator
Aer the device acvaon, you are required to add an administrator. You can set the
administrator's user name, the card No, and ngerprint.
Steps
Note
Parts of device models supports the ngerprint
funcon.
1. En
ter the New Admin page.
Figure 6-1 Add Administrator
2. En
ter the administrator's parameters.
ID (Employee ID)
By default, the ID No. will be increased in sequence. You can edit the ID according to your
preference.
Note
• The ID refers to the user aendance serial No.
•
The ID should be between 1 and 99999999 and should not start with 0.
• The ID should be used for once.
Name
En
ter the new user name.
Access Control Terminal User Manual
23