User's Manual

1. Enter Time & Aendance module.
2. Click Aendance
Sengs → General Rule .
3. Select the day(s) as weekend, such as Saturday and Sunday.
4. Click Save.
Congure Overme Parameters
You can congure the overme parameters for workday and weekend, including overme level,
work hour rate, aendance status for overme, etc.
Steps
1. Click Time & Aendance → Aendance Sengs → Overme .
2. Set required informaon.
Overme Level for Workday
When you work for a certain period aer end-work me on workday, you will reach dierent
overme level: overme level 1, overme level 2 and overme level 3. You can set dierent
work hour rate for three overme levels, respecvely.
Work Hour Rate
W
ork Hour Rate is used to calculate work hours by mulplying it by overme. When you
w
ork for a certain period aer end-work me on workday, you will reach dierent overme
level. You can set dierent work hour rates (1-10, can be a decimal) for three overme levels.
For example, your valid overme is one hour (in overme level 1), and the work hour rate of
overme level 1 is set as 2, then the work hours in the period will be calculated as 2 hours.
Overme Rule for Weekend
Y
ou can enable overme rule for weekend and set calculaon mode.
3. Click Save.
Congure
Aendance Check Point
You can set the card reader(s) of the access point as the aendance check point, so that the
authencaon on the card readers will be recorded for aendance .
Before You Start
You should add access control device before conguring aendance check point. For details, refer
t
o Add Device .
Steps
Note
By default, all card readers of the added access control devices are set as aendance checkpoint.
1. En
ter the Time & Aendance module.
Access Control Terminal User Manual
98