User Manual

42
Section 14: Linkage Installation
Step 20
Slide a clevis retainer onto a nylon clevis. Thread a
clevis onto a 6" wire a minimum of 10 turns.
Step 21
Center the aileron servo electronically using the radio
system. Install a servo arm onto the aileron servo.
Attach the pushrod with clevis to the control horn.
Physically place the aileron control surface in
neutral. Mark the pushrod where it crosses the
holes in the servo arm.
Step 22
Bend the wire 90 degrees at the mark made in the
previous step. Cut the wire 3/8" above the bend.
Step 23
Slide the wire through the outer hole in the aileron
servo arm. Secure the wire using a nylon wire keeper.
Step 24
Repeat Steps 16 through 23 for the other
aileron servo.
Step 25
Use a 5/64" drill bit to drill a hole in the
throttle servo arm.
Step 26
Attach a quick connector to the servo arm using
quick connector washers and retainers.