User Manual

Section 12: Fuel Tank Installation

Step 5

Make the proper connections to the engine, using the

engine manufacturer’s instructions. If you are using a

four-stoke, make sure to route the crankcase vent to

the outside of the cowling.

Section 13: Radio Installation

Step 2

Temporarily install the throttle servo. Mark the

locations for the servo screws using a felt-tipped pen.

Required Parts

• Fuselage assembly • Wing assembly

• Servo w/hardware (5) • #2 x 3/8" screws (8)

• 3/8" x 5/8" x 5/8" servo mounting block (4)

Required Tools and Adhesives

• Drill • Drill Bit: 1/16"

• 6-minute epoxy • Thin CA

• Felt-tipped pen • Hobby knife

• Phillips screwdriver (small) • Ruler

• 9" Servo Extension (JRPA097) (2)

• 12" Servo Extension (JRPA098) (2)

Step 1

Install the recommended servo hardware (grommets

and eyelets) supplied with your radio system onto

five servos (elevator, rudder, throttle and 2 ailerons).