User's Manual

®
RF5010 and RF5210
1-1/4” x 4-7/8” Square Corner Faceplate
ANSI Metal Jamb Installation
RF5000 or RF5200 with 501 Faceplate
1-1/4” x 4-7/8” Square Corner Faceplate
ANSI Metal Jamb Installation
RF5000 or RF5200 with 501 Faceplate
Installation Instructions
Cutout Template
Product
Applications
Electrical
Cable detail
Certifications
Warranty
Description
Dimensions
Orientation
Compatibility
Access Control Systems
Proximity Cards
Frequency
Indicators
Supervision
Electric Strike and Proximity Card Reader with
Antenna Module Mounted Separately in Frame
See page 4
Non handed, Reversible
Open Architecture
Interfaces with Wiegand Protocol Systems
Supports HID 26 39 Bit Formats
Supports HID 125 KHz Credentials
Red/Green LED and Buzzer
Door Position Switch and Latchbolt Monitor
Frames
Trim Enhancer
Locks
Latchbolts Released*
Environment
Temperature
Humidity
Steel, Aluminum, Wood
Included
Cylindrical
RF5010: Accomodates up to 5/8" Latchbolt
RF5210: Accomodates up to 3/4" Latchbolt
Suitable for Exterior Doors
32 F 150 F (0 C 65 C)
5 95%, Non-condensing
Reader Module
Distance to Host
Recommended Type
Electric Strike Module
Distance to Power
Recommended Type
500 ft. Max.
18 22 AWG (Dependent on Distance) Stranded and Shielded
See Page 3
See Page 3
Compliance
Security
FCC Part 15 (USA and Canada)
UL 1034, Burglary-Resistant Listed
ANSI/BHMA 156.31, Grade 1
MEA New York City Accepted
Lifetime Waranty
Inswing Version
HYBRID ELECTRIC STRIKES: INSWING VERSIONHYBRID ELECTRIC STRIKES: INSWING VERSION
HES, Inc.
22630 N. 17th Ave.
Phoenix, AZ 85027
800-626-7590
3 -3/8"
86
RF5010: 11/16"
RF5210: 13/16"
21
1-1/4"
32
4- 7/8"
124
4-1/8"
105
3/8"
10
1"
1-5/16"
33
5/8"
17
25
17
© 2007 HES, Inc.
0000000000.001 rev A
Reader/Antenna Door Position Switch Hybrid Electric Strike
®
Reader Module
Operating Voltage 10 14VDC
Operating Current 125 mA Max. at 12VDC
Electric Strike Module 250mA @12VDC
HID is a registered trademark of HID Corporation.
14
*
Faceplate options accommodate
various keeper and latchbolt
actions. For more detail, contact
HES tech support
at 800-626-7590
1-1/4” x 4-7/8” Square Corner Faceplate
ANSI Metal Jamb Installation
RF5010 or RF5210 with 501 Faceplate
Warning: Changes or modification to this device not expressly approved by HES, Inc. could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a class [B] digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
This class [B] digital apparatus meets all requirements of the Canadian interference Causing Equipment Regulations.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Cet appareillage numérique de la classe [B] répond à toutes les exigences de l’inerférencé canadienne causant des
réglements d’équipement. L’opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer
l’interférence nocive, et (2) ce dispositif doit accepter n’importe quelle interférence reçue, y compris l’interférence qui
peut causer l’opération peu désirée.