Instructions / Assembly

Assembly — Close-to-Ceiling Mounting

Assembling the fan

Preparing the motorPreparing the canopy

□ Remove the cotter pin (GG), clevis pin (FF) and the

two collar setscrews (HH) from the motor collar.

□ Remove three of the six collar mounting screws with

lock washers (II) (every other one) from the collar on

top of the fan motor assembly (G).

WARNING: Failure to completely tighten the three collar

mounting screws (II) could result in the fan becoming loose

and possibly falling.

□ Remove the mounting bracket (A) from the canopy (C)

by loosening the four canopy mounting screws with

lock washers (EE) on the top of the canopy (C).

Remove the two non-slotted canopy mounting

screws with lock washers (EE) and loosen the slotted

canopy mounting screws with lock washers (EE).

□ Remove the canopy bottom cover (D) from the

canopy (C).

□ Make sure the slot openings of the canopy ring (B)

are on top, and then proceed to place the canopy ring

(B) and canopy (C) over the collar at the top of the fan

motor assembly (G).

□ Align the mounting holes in the bottom of the canopy

the holes in the top of the fan motor assembly (G).

Fasten using the three collar mounting screws with

lock washers (II) previously removed.

□ Tighten the collar mounting screws (II) securely.