Installation Guide
Item #1001 492 880
Model #HD38683
Use and Care Guide
LOW VOLTAGE LED CLEAR STAIR LIGHT
Part Description Quantity
A
Cap
1
B
Screws
2
C
Housing
1
D
Wire
1
E
Wire
1
F
Connector
1
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING: The wire connector (F) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall be 12-16 AWG type
underground low Energy Circuit Cable or SPT2W.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light tting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6” (15.24 cm).
• Do not submerge xture in water.
□ Find a location on the deck where you want to mount the light.
□ Using the template provided with the instruction manual, place it
over the deck and use a sharp object or a pen to mark where you
are going to put the screws and drill the hole. Drill a hole of 1/2’’
where specied.
□ Pass the wire (D) through the deck.
□ Make sure the housing is covering up the hole.
□ Use the two (2) provided screws (B) to attach the light.
□ Snap the cap (A) to the light by pressing gently on both sides.
□ Connect the wires (D) and (E) together by using the connectors
on both end of the wires. Tighten the connectors by screwing the
plastic cap.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
□ Place the wire connector (F) on opposite sides of the low
voltage cable (not included) where the xture will be located.
□ Align and t the main low voltage cable vertically to the slot of
the wire connector (F) as shown.
□ Press the wire connector (F) together until fully seated and
locked around the cable. Pre-set prongs will pierce the cable
insulation and establish contact. Turn on the power unit. If the
light xture does not turn on, repeat the previous steps.
□ Once the clip-on connector (F) is in place, wrap it with
electrical tape for additional protection.
□ CAUTION BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
□ After all xtures are installed, turn on the transformer.
F
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTIO
N.
ETL LISTED UNDER MODEL # U000-1712
Please read and save these instructions
A
B
C
D
E
F
CAUTION: Safe for outdoor operation
WARNING: Install in accordance with all local codes and ordinances.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Click
Click
Click
Housing (C)
Screws (B)
Cap (A)
Wire (D)
Wire (E)