Instructions / Assembly

14
Maintenance
Storage between uses:
□ Turn the control knob to “OFF” position.
□ Disconnect LP source.
□ Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).
□ If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.
Storage during periods of extended inactivity or when transporting:
□ Turn the control knob to “OFF” position.
□ Disconnect LP source and move to a secure, well ventilated location outdoors. DO NOT store in a location that will exceed 125 °F．
□ Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).
□ If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages.
Care and Cleaning
To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance
activities on a regular basis:
□ Keep exterior surface clean.
□
□ While washing your unit, be sure to keep the area around the burner dry at all times. If the gas control is exposed to water, do NOT try to
use it. It must be replaced.
□
□ At least once a year, the unit should be inspected for the presence of spiders, spider webs or other insects.
□
Heater does NOT reach the desired temperature.
Heat glow is excessively uneven.
Heat makes popping noises.
□
n burner
holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
□
ts
develop.
□ The burner is made from stainless steel, but extreme heat and a corrosive environment can cause surface corrosion to occur. This can be
removed with a brass wire brush. Inspect the burner at least annually for cracks, insect nests, excessive corrosion or any other damage.
tion.
NOTE: Wait until heater is cool before covering.
NOTE: Wait until heater is cool before covering.