Instructions / Assembly

Preparing the canopy

Preparing the motor

□ Remove the canopy ring (C) from the canopy (D).

□ Remove the two non-slotted canopy mounting screw

(BB) from the canopy (D), and loosen the slotted

canopy mounting screw (BB) on the canopy (D).

□ Remove the canopy (D) from the mounting bracket (A)

by turning the canopy (D) counterclockwise.

Assembling the fan

□ Remove the cotter pin (DD) and clevis pin (CC), and

loosen the two collar setscrews (EE) from the fan

motor assembly (H) collar.

Assembly — Standard Ceiling Mounting

WARNING: Failure to properly install the cotter pin (DD)

could result in the fan loosening and possibly falling.

□ Route the wires exiting from the top of the fan motor

assembly (H) through the coupling cover (G), canopy

ring (C), canopy (D) and then through the hanger

ball/downrod assembly (F).

□ Align the holes at the bottom of the hanger

ball/downrod assembly (F) with the holes in the collar

on top of the fan motor assembly (H).

□ Carefully insert the clevis pin (CC) through the holes

in the collar and the hanger ball/downrod assembly

(F). Be careful not to jam the clevis pin (CC) against

the wiring inside the hanger ball/downrod assembly

(F).

□ Insert the cotter pin (DD) through the hole near the

end of the clevis pin (CC) until it snaps into the locked

position.

□ Firmly tighten the two collar setscrews (EE) on top of

the fan motor assembly (H).

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

NOTE: If a longer downrod is needed (not included), take

out the screw located in the hanger ball, lower the hanger

ball and remove the pin. Remove all three pieces from the

downrod, and assemble them onto the new longer downrod

before proceeding step 3.