Instructions / Assembly

Assembly — Hanging the Fan (continued)

Setting up the remote control

Setting the code on the remote:

Remove the battery cover on the back of the remote

control (G) by pressing ﬁrmly on the arrow and sliding

the cover off.

Slide the code switches to your choice of either up or

down. The factory setting is up.

Install the 23A 12V battery (BB) (included).

Replace the battery cover on the remote control (G).

Setting the code on the receiver (EE) (located inside top of the

motor housing):

Slide the code switches on the receiver (EE) to the same

positions as set on the remote control (G).

After checking the switches, insert the receiver (EE) into the

mounting plate (A) with the ﬂat side of the receiver facing

the ceiling.

NOTE: The frequencies on your receiver and remote control

have been preset at the factory. Before installing the receiver,

make sure the dip switches on the receiver and remote

control are set to the same frequency. The dip switches on

the remote control are located inside the battery

compartment.

NOTE: The battery will weaken with age and should be

replaced before leaking takes place as this will damage the

remote control. Dispose of the used battery properly and keep

the battery out of the reach of children.

NOTE: The frequency switches on the receiving unit are

covered with a rubber cover. Remove the rubber cover and

then replace it after making any changes to the frequency

switches.

23A 12V

3 41 2

DIP

3 41 2

DIPON