Instructions / Assembly

Assembly — Attaching the Fan Blades

Removing the rubber

packing mounts

Fastening the blade assemblies

to the motor

Attaching the blades to the

blade arms

□ The fan motor assembly (E) is shipped with rubber

packing mounts (TT) to prevent movement during

transportation. Remove the ﬁve rubber packing

mounts (TT) from the fan motor assembly (E) and

discard prior to attaching the blade arms (G).

□ Attach the blades (F) to the blade arms (G) using the

three blade attachment screws and ﬁber washers

(AA). Insert a blade attachment screws and ﬁber

washers (AA) into the blade arm (G), but do not

tighten.

□ Repeat for the two remaining screws and ﬁber

washers (AA).

□ Tighten each screw securely starting with the center

screw. Make sure the blade (F) is straight.

□ Repeat these steps for the remaining blades.

□ Fasten the blade assemblies (G) to the fan motor

assembly (E) by lining up the slots (UU) of the blade

arms (G) with the tabs (VV) on the motor.

□ Tighten the two blade arm screws and lock washers (II)

already installed in the blade arms (G).

□ Repeat this procedure for the remaining blade arms (G).

WARNING: To reduce the risk of personal injury, do not

bend the blade arms (G) while installing, balancing the blades

(F), or cleaning the fan. Do no insert foreign objects between

rotating fan blades (F).