Instructions / Assembly

ManualsBrandsHampton Bay ManualsOutdoorsBlue Springs 3-Piece Patio Bistro Set

IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!

TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT

Step3: Attach the leg to the leg

using nut (E)and washers(F) as shown in diagram 2.

Guiding the bolts already in place on the table legs

(each leg has two bolts) through the holes in the leg

connector bracket. Add a washer and a nut to the end

of each bolt. Hand tighten three to four turns only. Do

not tighten completely. Repeat on other three legs.

connector bracket(B) (C)

Step 1: Remove all protective materials and set parts on a

flat, non-abrasive surface. Identify parts packed in

carton against the parts list. If you are missing any

parts or are unsure how to proceed with the assembly,

call our Customer Service Center at 1-800-206-8095.

Do not attempt to assemble table if any parts are

missing or damaged.

Step 4: After making any necessary adjustments to the

alignment of the table legs(C) and the leg connector

bracket(B), use the hex bolt driver (J) and hex wrench(I)

to tighten all the bolts and nuts.Note: each bolt must be

tightened a few revolutions at a time. In order to apply

equal pressure to all bolt joints, we recommend working

in a cross corner (X fashion).Repeat until all bolts are

tight. Do not over tighten. Over tightening may strip

bolts. After tightening all the bolt Cover all the bolt and

bolts and nuts with bolt covers(G)and pvc nuts cover(H).

IMPORTANT NOTE: Damage to welds or frames

resulting from over tightened bolts or improper assembly

is not covered under our warranty. Please read all

instructions carefully before assembly.

A-ET-1148-D22

TABLE LEG

LEG CONNECTOR

BRACKET

TABLE TOP

PARTS LIST DESCRIPTION

QTY

E6.5 X 1.0 MM

WASHER

NUT

HEX BOLT DRIVER

1/4" X 15 MM BOLT

TOUCH-UP PAINT

PE CAP

* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE

FOOT CAP

Step 5: With the help of another person, turn the table in the

upright position. Your table is now ready for use.

Step 2: Place the table top upside down on a flat, non-

abrasive surface. Attach table leg (C)to table rim

(A)using bolts(D) and washers(F) as shown in diagram 1.

Guide bolt through hole in table leg, into pre-drilled

hole in the table rim. Hand tighten three to four turns

only. Do not tighten completely. Some adjustments

may be necessary to ensure proper alignment of the

table legs. Repeat for other two legs.

diagram 4.

diagram 1.

diagram 2.

diagram 3.

Page 2

1/4" NUT

NUT COVERPVC

HEX WRENCH