Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Loosen, but do not remove, the two setscrews (HH) on the

collar (II) on top of the motor housing.

□ Align the holes at the bottom of the downrod (B) with the

holes in the collar (II) on top of the motor housing.

□ Carefully insert the hanger pin (DD) through the holes in the

collar (II) and downrod (B). Be careful not to jam the hanger

pin (DD) against the wiring inside the downrod (B).

□ Insert the locking pin (EE) through the hole near the end of

the hanger pin (DD) until it snaps into its locked position.

□ Re-tighten the two setscrews (HH) on the collar (II) on top of

the motor housing.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the two canopy screws (FF) located in the “L

shaped” slots.

□ Remove and save the two canopy screws (FF) and lock-

washers (GG) in the round holes. This will enable you to

remove the mounting bracket (A).

□ Make sure the slot openings are on top, route the

wires from the fan-motor assembly (D) through the

canopy (C), and then through the ball/downrod as-

sembly (B).

WARNING: Failure to properly install the locking pin could

result in the fan becoming loose and possibly falling.