Installation Guide

12
Assembly - Attaching the Fan Blades
Attaching the fan blades
2
□ Mount the fan blades (G) to the blade bracket (H) by aligning
the three key-slot holes in the blade (G) with the three posts
on the top of the blade brackets (H).
□ Hold the blade (G) close to the blade bracket (H) and press
the blade (G) down rmly. Ensure the key-slot holes are
properly seated on the blade arm posts.
□ While still holding the blade (G) down, rmly slide the
blade (G) away from the bracket (H) side until the blade (G)
engages in the locking mechanism (TT).
□ Make sure the locking mechanism (TT) at the rear of the
blade bracket (H) springs upward and butts against the edge
of the blade (G) indicating a secure connection.
□ Visually inspect the top of the blade bracket (H) to ensure
the locking mechanism (TT) is securely in place.
□ Repeat for the remaining blades (G).
D
G
H
TT
NOTE: Your fan blades are reversible. Select the blade
side nish which best accentuates you decor.
Assembly - Attaching the Light Kit
Attaching the light kit
1
□ Remove the three screws (UU) from the light kit tter
assembly (E).
□ Connect the wires exiting the bottom of the motor assembly
(D) by connecting the molded adaptor plugs together (blue
to black, and white to white).
□ Slide the light kit (E) and secure it to the switch housing
using the three screws (UU) that were removed in the rst
step.
WARNING: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
D
UU
E