Full Product Manual

HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
Assembly and Installation
Attaching and installing the light
1
Item #1005 697 369
Model #62909
□ Install the xture in the ground by pushing the stake (C).
□ Detach and place the wire connector (D) on opposite sides of the low
voltage cable (not included) where the xture will be located.
□ Align and t the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (D) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact. Turn on the power unit. If the light xture does not turn
on, repeat operations 2 and 3.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
Option 1: with extension post
□ Twist the connector (2) out at the bottom of the extension post (B), and
remove the connector (2).
□ Attach the xture bollard (A) to the extension post (B) by routing the xture
wire (1) through the extension post (B) and placing the xture bollard
(A) onto the threaded end of the extension post (B) and then twisting
clockwise.
□ Route xture wire (1) through the the connector (2) and twist the
connector (2) back into the bottom of the extension post (B).
□ Insert the xture wire (1) into the groove located on the top of ground
stake (C).
□ Attach the extension post (B) to the stake (C) by placing the bottom of the
extension post (B) onto the top of the stake (C) and twisting clockwise.
Connecting the wires
2
A - Fixture bollard x 1 B - Extension post x 1 C - Stake x 1 D - Connector with 12 in. wire length
(attached to xture) x 1
CAUTION: The wire from the low voltage power unit shall be
12-16 AWG type underground Low Energy Circuit Cable.
IMPORTANT: Protect the wiring by routing it in close
proximity to the light or next to a building structure such as
a house or deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in order
to connect to the main secondary wire.
Do not submerge xtures in water.
NOTE: Do not use a hammer. If the ground is hard, use water
to soften it or a trowel to loosen the soil.
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
A B C D E
E - Remote control x 1
Option 2: without extension post
□ Twist the connector (2) out at the bottom of the extension post (B), and
remove the extension post (B). Route the xture wire (1) through the
connector (2), and then twist the connector (2) into the bottom of the
xture bollard (A).
□ Attach the xture bollard (A) to the stake (C) by placing the bottom of the
xture bollard (A) onto the top of the stake (C) and twisting clockwise.
2
2
3
A
B
C
A
C
1
1
1
D
Use and Care Guide
LED Low Voltage Path Light
WARNING: Risk of electric shock. Do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
Remote Control
3
□ Prior to using the remote, remove the pull
tab (4) at the base of the remote control
(E) to allow battery contact.
□ Press the buttons on the remote (E) to
select the desired mode or push the
button (3) on the xture bollard to select
the desired mode.
Option 1:
with extension post
Option 2:
without extension post
4
E