Instructions / Assembly

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Assembly - Attaching the Light Kit

Attaching the light kit tter assembly

☐ Remove the three screw (VV) from the light kit tter assembly

(F) and save them.

☐ Align the three holes in the switch cup below the fan motor

assembly (E) with the three holes in the switch cover of the

light kit tter assembly clears the reversing switch in the

switch cup.

☐ Connect the wires from the light kit tter assembly (F) to

wires from the fan motor assembly (E) by connecting the

molded adaptor plugs together. Carefully tuck all wires and

splices into the switch cup.

☐ Position the light kit tter assembly (F) and re-install the

three screws that were removed in rst step to secure the

light kit tter assembly properly.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light xture.

NOTE: Notice the location of the fan’s slide switch. This is

the switch used to change the fan’s directional rotation.

For more information on the operation of this switch, see

Operating Your Fan on page 14.

Installing the bulb and glass bowl

☐ Remove the nial (TT), bottom cover (SS), hex nut and the

rubber washer from the threaded nipple of the light kit

tter assembly (F).

☐ With power off, install the LED bulb (L) by screwing them

into the light bulb sockets. Position the glass bowl (I) over

the threaded nipple, re-install the rubber wash and hex

nut to secure the glass bowl (I) properly.

☐ Re-install the bottom cover (SS) and nial (TT) over the

threaded nipple and tighten the nial (TT) securely.

☐ Attach the pull chain extension (EE ) provided to the light

pull chain and fan pull chain.