Installation Guide

Assembly - Attaching the Blades

Attaching the blade bracket

□ Fasten the blade bracket (I) to the motor (E) by inserting the

alignment post into the slot on the bottom of the fan-motor

assembly (E) and tightening the motor screws (GG) that are

pre-assembled to the blade bracket (I).

□ Repeat for the remaining four blade brackets (I).

Assembly - Hanging the Fan (continued)

Mounting the fan-motor assembly

(standard mount)

□ Align the locking slots of the canopy (B) with the two screws

(FF) and alignment post (EE) in the mounting bracket (A).

□ Push up the canopy (B) and turn clockwise until the

alignment post (EE) engages to the round hole and the

screws engage to the key slots.

□ Firmly tighten the two mounting screws (FF).

□ Install the decorative bottom cover (C) by aligning the cover

slots with screws in the bottom of the canopy (B). Rotate the

bottom cover (C) clockwise to lock in place.

WARNING: When using the standard ball/downrod mounting,

the tab in the ring at the bottom of the mounting bracket

must rest in the groove of the hanger ball. Failure to properly

seat the tab in the groove could cause damage to the wiring.