Warranty

8
Assembly - Hanging the Fan
Attaching the fan to the electrical
box
□ Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□ Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws (LL)
provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and
the outlet box. The at side of the slide-on mounting bracket (A)
should face toward the outlet box, as shown.
□ Securely tighten the two mounting screws (LL).
1
WARNING: To reduce the risk of re, electric shock
or personal injury, mount to an outlet box marked
“Acceptable for fan support of 35 lbs. (15.9 kg) or less,”
and use the screws provided with the outlet box.
Hanging the fan
2
□ Carefully lift the fan-motor assembly (D) up to the slide-on
mounting bracket (A).
□ Insert the ball portion of the ball/downrod assembly into the
socket of the slide-on mounting bracket.
□ Turn the ball/downrod assembly clockwise until it is seated
with the tab of the slide-on mounting bracket aligned with the
slot in the ball.
WARNING: The hook (MM) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (MM) breaking, causing the fan to
fall. The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (MM) it is
critical that you use one of the non-slotted (round) holes in
the canopy (C).
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (LL).
A
B
D
C
Standard mount
LL
LL
A