Installation Guide
12
Assembly - Attaching the Light Kit (continued)
Installing the bulbs and glass
shade
PULL CHAIN OPERATING INSTRUCTIONS
REVERSE SWITCH OPERATING
INSTRUCTIONS
11
□ With the power off, install two bulbs (J) (Max. 14W, included)
by twisting them into the light bulb sockets.
□ Place the glass shade (I) into the light kit tter assembly (E),
aligning the three at areas on the top ange of the glass
shade (I) with the three raised dimples in the light kit tter
assembly (E). Then turn the glass shade (I) clockwise until it
stops.
□ Attach the pull chain fobs (FF) to the pull chains exiting the
pull chain guide.
E
I
J
FF
NOTE: Notice the location of the fan’s slide switch. This is the
switch used to change the fan’s directional rotation. For more
information on the operation of this switch, see “Slide Switch
Operation Instructions” on page 12.
NOTE: Periodically check that the glass shade is seated fully
clockwise in the light kit assembly.
Operation
Turn on the power and check the operation of the fan. The pull
chain controls the fan speeds as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off
The appropriate speed settings for warm or cool weather depends
on factors such as the room size, ceiling height, and number of
fans.
The slide switch controls the direction of the blades: forward (switch
down) or reverse (switch up).
Warm weather - (Forward) A downward airow creates a cooling
effect. This allows you to set your air conditioner on a warmer
setting without affecting your comfort.
Cool weather - (Reverse) An upward airow moves warm air off
of the ceiling. This allows you to set your heating unit on a cooler
setting without affecting your comfort.
NOTE: Wait for the fan to stop before reversing the direction of
blade rotation.