Installation Guide

INSTALLATION INSTRUCTIONS
New 06/18/2004
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
Fig. 1
Fig. 2
Fig. 3
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off power at the circuit breaker and remove old fixture
including the crossbar.
2. Carefully remove the fixture from the carton and check that all
parts are included as shown in the illustration.
3. Secure Loop (A) To Top Housing (B)
4. Connect one end of Drop Rod (D) to the Top Housing (B) and the
other end of Drop Rod (D) to the Glass Ring (G) using Screw
(C). Do the same with the other Drop Rods.
5. Thread Rod (F) into the coupling on the bottom of light Assembly.
6. Install the light bulbs in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!)
7. Place Glass Shade (H) through the Rod (F) and secure with
Finial (I) as shown in Fig.1.
HANGING THE FIXTURE (Fig. 2)
8. Thread Nipple into Loop until snug.
9. Thread other end of Nipple with Loop attached into crossbar until
snug.
10. Place Lock Washer over end of Nipple protruding through
crossbar and thread Hex Nut onto nipple until tight.
11. Take the crossbar assembly and mount to ceiling junction box
with junction box screws. Tighten screws securely with
screwdriver.
12. By measuring determine correct number of links needed for
proper hanging height.
13. Use a pair of pliers to open one end link of the chain, attach the
chain to the fixture’s loop, close the link. Slip Lock Collar
followed by the Canopy over the chain. Open the other end link
of the chain and lift the fixture to attach to the ceiling loop, close
the chain link.
14. Lace the fixture’s wires through the chain links and pull until taut.
Feed the fixture wires through the loop and Nipple and pull until
taut.
CONNECTING THE WIRES (Fig. 3)
15. At this point, connect the electrical wire as shown in figure 3,
making sure that all wire connectors are secured. If your outlet
has a ground wire (green or bare copper), connect the fixtures
Ground Wire to it. Otherwise, connect the fixture Ground Wire
directly to the crossbar using the Green Screw provided.
16. Tuck these wire connections neatly into the ceiling junction box
and then raise the canopy all the way to the ceiling. Raise the
Lock Collar and thread onto ceiling Loop protruding through
canopy.
Your installation is now complete. Return power to the junction
box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
LA-826E/S
In the event that you should have any installation question or are missing
parts, please contact Customer Service. Customer service may be reached
weekdays a 1-800-527-0998 between the hours of 8:00am and 5:00pm PST
(Pacific Standard Time).
Notice: It is important to use proper chain pliers (not included)
To OPEN and CLOSE the chain included with this fixture. Do
not open them with other tools that may twist or stress the
chain links. It is important to use proper chain pliers like the
ones shown in the diagram.
G
H
I
C
D
F
A
B
C
Nipple
Screw
Canopy
Loop
Chain
Hex Nut
Lock Washer
Crossbar
Loop
Lock Collar
Junction Box
(Ceiling)
FIXTURE
WIRES
Black or
Smooth
H
O
USE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
O
USE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
H
O
USE
WIRES
Green
(Ground)