Installation Guide

Turn on the power and check the operation of the fan. The fan pull

chain controls the fan speed as follows:

1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off

The appropriate speed settings for warm or cool weather depends on

factors such as the room size, ceiling height, and number of fans.

The slide switch (XX) controls the direction of the blades: forward

(switch left) or reverse (switch right).

A. Warm weather - (Forward) A downward airow creates a cooling

effect. This allows you to set your air conditioner on a higher setting

without affecting your comfort.

B. Cool weather - (Reverse) An upward airow moves warm air off of the

ceiling. This allows you to set your heating unit on a lower setting

without affecting your comfort.

NOTE: Wait for the fan to stop before reversing the direction of the

blade rotation.

Operation

OPERATING YOUR FAN

A. Warm Weather

B. Cool Weather

Assembly - Attaching the Fan without the Light Kit

Assembling the fan without the

light kit

☐ Remove the three light kit mounting screws (VV) from the

switch cup cover (WW) of the light kit tter assembly (F).

☐ In order to use the fan without light kit, remove the

switch cup cover (WW) from the top of the light kit tter

assembly (F) by removing the center hex (YY) inside the

switch cup cover (WW), and then thread the switch cup

cover (WW) off the threaded nipple on the top of the light

kit tter assembly (F).

☐ Press the plastic plug (HH) (provided) into the center hole

of the witch cup cover (WW).

☐ Position the switch cup cover (WW) onto the switch cup

below fan motor assembly (E) and re-install the three

light kit mounting screws (VV) that were removed on rst

step.

☐ Attach the pull chain extension (EE) provided to the fan pull

chain.