Use and Care Manual

Care and Cleaning

Electrical Shock Hazard.

Do not immerse kettle, power base, or plug in water or other liquid.

w WARNING

To avoid scale/lime deposit build-

up, empty kettle after each use.

Wipe the exterior of kettle with a

damp cloth. Do not use abrasive

scouring pads or powders since

they may scratch the smooth

surface of the kettle.

To remove discoloration or scale/lime deposit from heating element:

Place 1/2 teaspoon cream of tartar (available in the spice aisle of

grocery store) into the kettle. Then fill the kettle 1/2 full with water.

Plug in, turn ON (I), and bring to boil. Turn OFF (O), let cool, and

rinse several times with clean tap water.

If Kettle Floor Discolors: It is normal for stainless steel heating

elements to discolor. This does not affect the performance of the

kettle. Do not use abrasive scouring pads or cleaners since this

may damage the stainless steel surface.

If Kettle Boils Dry: The heating element is protected by two

automatic safety devices. If your kettle is accidentally switched on

without being filled with water, or is allowed to boil dry, the kettle

will automatically switch off. You should:

• Turn the switch to OFF (O), unplug, and wait about 20 minutes for

the element to cool down.

• Refill the kettle; then use as normal and check that the kettle

functions correctly.

If Kettle Does Not Work: Make these simple checks before calling

the toll-free customer assistance number:

• Have you turned power switch to ON (l) position?

• If the kettle heats but does not boil, it might need descaling.

• Has the kettle been accidentally switched on without being filled

with water or allowed to boil dry? Turn the switch to OFF (O), wait

20 minutes, and try again.

• Is cord firmly plugged into the outlet and kettle firmly seated in the

base?

Anti-Scale Mesh Filter: Scale is caused by lime and calcium in hard

water. The mesh filter will prevent these suspended particles from

being poured out of the kettle. The filter should be cleaned periodically

to ensure optimum performance. To clean the filter, unplug kettle and

allow to cool. The mesh filter may be removed by pressing on filter tab,

which is visible through the kettle opening. Rinse filter under running

water and brush with a soft brush. An old, clean toothbrush works well.

840219400 ENv02.indd 5840219400 ENv02.indd 5 6/20/12 3:55 PM6/20/12 3:55 PM