Install Instructions
Table Of Contents
- English (US)
- 1. Limited warranty
- 2. Symbols used in this document
- 3. General information
- 4. Mechanical installation
- 5. Electrical installation
- 6. First start-up
- 7. Settings
- 8. Control panel
- 9. Overview of settings
- 10. Pump setting
- 11. Selection of control mode
- 12. Fault finding
- 13. Technical data
- 14. Disposal
- Español (MX)
- 1. Garantía limitada
- 2. Símbolos utilizados en este documento
- 3. Información general
- 4. Instalación mecánica
- 5. Instalación eléctrica
- 6. Arranque inicial
- 7. Configuración
- 8. Panel de control
- 9. Descripción de los ajustes
- 10. Ajuste de la bomba
- 11. Selección de un modo de control
- 12. Localización de averías
- 13. Datos técnicos
- 14. Eliminación
- Français (CA)
- 1. Garantie limitée
- 2. Symboles utilisés dans cette notice
- 3. Informations générales
- 4. Installation mécanique
- 5. Installation électrique
- 6. Première mise en service
- 7. Paramétrages
- 8. Panneau de commande
- 9. Aperçu des réglages
- 10. Réglage du circulateur
- 11. Sélection du mode de régulation
- 12. Grille de dépannage
- 13. Caractéristiques techniques
- 14. Mise au rebut
15
English (US)
6. First start-up
Do not start the pump until the system has been filled with liquid
and vented. Furthermore, the required minimum inlet pressure
must be available at the pump inlet. See section 13. Technical
data.
The system cannot be vented through the pump. The pump is
self-venting.
Step Action Illustration
1
Switch on the power supply
to the pump.
Note: When switched on, the
pump will start after
approximately 5 seconds.
TM05 5550 3812
2 Control panel at first start-up.
TM05 5551 3812
3
The pump has been factory-
set to the intermediate
proportional-pressure curve.
Select the control mode
according to the system
application.
TM05 5551 3812