Instructions / Assembly

www.gronomics.com East Bethel, MN USA 763-753-7374

Continued

Parts List

ITEM QTY. PART # DESCRIPTION

1 4 R1900 Corner Post, 4” x 4” x 19”

2 2 R7011 Side Rail w/Cleat, 45” x 5-1/2” x 1”

3 2 R4501, R4501L Side Rail, (One w/Logo), 45” x 5-1/2” x 1”

4 4 R1450 Side Rail, 14-1/2” x 5-1/2” x 1”

5 2 R1552 Corner Notched Bottom Board, 15” x 5-1/2” x 1”

6 6 R1550 Bottom Board, 15” x 5-1/2” x 1”

7 4 R3100 Post Cap, 4” x 4” x 1-1/2”

8 1 2003 Fabric Liner, 36” x 52”

Rustic Planter Box (18” x 48”)

Assembly Instruction

Parts Identiﬁ cation

Stack matching pieces in piles. Using the parts list,

locate and count the individual pieces and verify that

you have received the correct number of pieces.

If any pieces are missing or replacement parts are

required, contact Gronomics at 1-855-299-6727.

NOTE: It is recommended to place a protective layer

between the ground and the pieces during assembly.

This will help prevent damage to the pieces.

RPB 18-48

Side Rail Assembly

Stand two 4” x 4” x 19” corner posts (Item 1) upright with slots facing you and

slots facing each post.

Locate a 45” x 5-1/2” side rail w/cleat (Item 2), (with cleat located at the bottom

and facing you). Install side rail w/cleat into the upper part of the slots and slide

down to the bottom of the slots.

Repeat procedure for the two remaining 4” x 4” x 19” corner posts and the 45” x

5-1/2” side rail w/cleat.

(Soil depth option: Cleats located as shown will provide a soil

depth of approximately 9”. Reverse side rail w/cleat installation,

cleats located at top, if a soil depth of approximately 6” is desired).

Cleat

Packaged & Inspected by: Date:

PAGE 1
Rustic Planter Box (18” x 48”) Assembly Instruction 1 Parts Identification RPB 18-48 Stack matching pieces in piles. Using the parts list, locate and count the individual pieces and verify that you have received the correct number of pieces. 1 2 3 6 4 If any pieces are missing or replacement parts are required, contact Gronomics at 1-855-299-6727. 5 7 8 NOTE: It is recommended to place a protective layer between the ground and the pieces during assembly.
PAGE 2
3 5 End Side Rail Assembly Install two 14” x 5-1/2” side rails (Item 4) into the slots at each end of the planter box and slide to the bottom of the slots. Bottom Board and Fabric Installation Place one 15” x 5-1/2” corner notched bottom board (Item 5) on each end of the planter box. 4 Place six 15” x 5-1/2” bottom boards (Item 6) into the planter box. (Gap boards evenly to allow for water drainage). 4 Place fabric liner into the planter box. Soil Capacity: 3.