Use and Care Manual

-18-
G0457 14" Industrial Bandsaw (Mfd. Since 5/11)
15. Replace the blade, and for now, only put
enough tension on it to keep it on the wheels.
16. Re-install the table pin and table insert.
17. Fasten the rear rail to the back of the table
with two M6-1 x 16 cap screws, as shown in
Figure 15.
19. Thread an M8-1.25 hex nut all the way onto
the fence lock lever shown in Figure 17, then
thread the lever handle into fence pivot block
and tighten the hex nut against the pivot
block to secure the handle.
Figure 15. Rear rail installed.
18. Attach the front rail to the front of the bandsaw
table with the two M6-1 x 20 hex bolts, 6mm
lock washers and flat washers, as shown in
Figure 16.
Figure 16. Installed front rail.
Figure 17. Fence lock lever installed on fence
assembly.
Pivot Block
Hex Nut
20. Place an 8mm flat washer on the resaw lock
handle and slide it through the hole in the
fence.
21. Thread the moving plate onto the end of the
locking adjustment handle threads.
22. Slide the resaw fence over the moving plate,
as shown in Figure 18, so the moving plate
fits inside the channel of the resaw fence.
Figure 18. Attaching resaw fence to standard
fence.
Moving
Plate
Resaw Lock
Handle