SDS
MATERIAL SAFETY DATA SHEET
STEEL PRODUCTS
ORIGINAL ISSUE DATE: 9/AUG./05’
Ⅰ. IDENTIFICATION
WIRE PRODUCTS
PRODUCT NAME:
STEEL PRODUCTS:
WIRE & WIRE PRODUCTS
COMMON NAME(S): SAME
1. 0.90 DIA. HAMMER & TACKER STAPLE
2. 0.86 DIA. HAMMER & TACKER STAPLE
3. 0.64 DIA. HAMMER & TACKER STAPLE
4. 0.85 DIA. HAMMER & TACKER STAPLE
Ⅱ. INGREDIENTS AND RECOMMENDED OCCUPATIONAL EXPOSURE LIMITS
Note: steel products under normal conditions do not present an inhalation
BASEMETAL & METALLIC
COATINGS
EXPOSURE LIMITS
CHEMICAL SYMBOL
% WT.
OSHA PEL ACGIH TLV
All Products:
Iron
Galvanized
Products:
Zinc
Fe
Zn
95.0
3.0
10.0 mg/M³
fume
5.0 mg/M³
5.0 mg/M³
fume
5.0 mg/M³
SEE ANNEX 1 FOR BALANCE OF INGREDIENTS. SEE ANNEX 3 FOR ANIL COATINGS.
SECTION 313 – SUPPLIER NOTIFICATION
This product contains threshold concentrations of the following toxic chemicals subjects to the
reporting requirements of Section 313 of the Emergency Planning and Community Right-to Know
Act of 1986(40CFR372):
Chromium, Manganese, Nickel and Zinc(Galvanized Coating Only) in the amounts noted above and
on ANNEX 1.
This information should be included in all MSDS’s that are copied and distributed for this material.
Ⅲ. PHYSICAL DATE
SPECIFIC GRAVITY(H=0>1): 7.85 SOLUBILITY IN WATER: NONE
BOILING POINT(Iron): 4950°F
EVAPORATION RATE
(Butyl Acetate=1): N/A
MELTING POINT(Base Metal): 2400°F
VAPOR PRESSURE(mm Hg): N/A
MELTING POINT(Metallic Coating): 800°F
VAPOR DENSITY(Air 1): N/A
APPEARANCE: Metallic Grey ODOR: NONE
Ⅵ. FIRE AND EXPLOSION HAZARD DATA
Steel products in the solid state present no fire or explosion hazard.
Ⅴ. REACTIVITY DATA