User Manual

Step 6 – Figure 11 shows how to place the wheels.
Place the metal plate inside (opposite side of the caster
wheels) and align the wheels outside. There should be
a pre-drilled hole that will guide you to secure the
wheels with bolts, nuts and washers.
Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.Griffin-Stands.com/Videos
Step 4 – Get the lid (Part G) and place on top. Behind the
lid (Part G) are the hinges that is attached to Back
Horizontal Plate (Part I) using a screw as shown in Figure
7. Now in between Back Horizontal Plate (Part I) and the
side panels screw in the L-Brackets for a more secure
back horizontal plate. (See Figure 8). Attach the four “L”
brackets. The front “L” brackets should be attached 1”
(2.5cm) from the top. The back “L” brackets should be
attached 2” (5cm) from the top.
Step 5 – Turn the stand to the side, at the base (Part A)
measure and divide to three sections. Measuring from
the front, the leading edge of the bracket closest to the
front should be 6” (15.2cm) and the leading edge of the
bracket closest to the back should be 13” (33cm). This is
where you will drill and screw in the L-Brackets. Do the
same step on the other side as seen on Figure 9. Also,
while the stand laying on one side you can install the
chrome corner brackets as shown in Figure 10.
Step 7 – Place the middle shelf (Part D) inside. There is a
support tab inside the stand where the shelf rests.
(Refer to Figure 12)