Owner's manual

❏

3. Now is a good time to organize the wires in the fuselage.

Connect the aileron and ﬂ ap servos to the Y-harnesses.

Straps to hold the wires in position can be made from #64

rubber bands (not included) cut into strips. The strips can be

glued over the wires. Remember, the wires from the wings

cannot be strapped down if the wings are to be removable.

❏

4. The pilot busts (not included, WBRQ1140) that we

installed had to be raised about 1/2" [12.7mm]. A piece of

balsa wood or foam (not included) can be used. Insert the

pilots from the bottom of the cabin and glue them in position.

❏

5. We recommend that a screw be installed through the

bottom of the cabin to help secure the pilots.

❏

6. Glue the cabin bottom cover in place.

❏

7. Clean the recess in the top of the cabin and the post on

the antenna with a paper towel dampened with denatured

alcohol. Glue the antenna post in the recess with epoxy or

silicone RTV.

Apply the Decals

1. The decals are die-cut from the factory.

2. Be certain the model is clean and free from oily ﬁ ngerprints

and dust. Prepare a dishpan or small bucket with a mixture

of liquid dish soap and warm water—about 1/2 teaspoon of

soap per gallon of water. Submerse one of the decals in the

solution and peel off the paper backing. Note: Even though

the decals have a “sticky-back” and are not the water transfer

type, submersing them in soap & water allows accurate

positioning and reduces air bubbles underneath.

Position decal on the model where desired. Holding the

decal down, use a paper towel to wipe most of the water away.

4. Use a piece of soft balsa or something similar to squeegee

remaining water from under the decal. Apply the rest of the

decals the same way.