User's Manual

118
Detail program description - Control adjust
Smoothing the Channel 1 curve
In the example below, sample reference points have
been set:
Reference point 1 to 0%
Reference point 2 to +25%
Reference point 3 to -75%
as described in the last section.
1
–50%
0%
0%
Normal
off
Input
Output
Point
C1 Curve
Curve
This "jagged" curve profi le can be smoothed
automatically simply by pressing a button.
First – assuming a situation is confi gured as presented
above – tap the center
ESC button on the left touch pad
to deactivate the value fi eld. Then use the arrow keys on
the left or right touch pad to move the marker frame in
an upw
ards direction to the "Curve" line. Now briefl y tap
the center
SET key on the right touch pad to activate the
value fi eld on the "Curve" line:
1
–50%
0%
0%
off
Normal
Input
Output
Point
C1 Curve
Curve
Use the arrow keys on the right touch pad to set the
curve value from "off" to "on" and complete this setup
procedure by briefl y tapping the center SET the center
SET key on the right touch pad or the center ESC key
on the left touch pad:
1
–50%
0%
0%
on
Normal
Input
Output
Point
C1 Curve
Curve
Note:
The curves shown here are for demonstration purposes
only and are not at all representative of real throttle/
airbrake curves. For real-wor
ld application examples,
see the programming examples from page 242 onwards.