User's Manual

GXP1610/GXP1620/GXP1625/GXP1628
Administration Guide
Page 28 of 47
seconds). The default value is 30 seconds.
Intercom User ID
Configures the intercom extension number for account 1 to dial out. This User
ID is mapped to the INTERCOM button on the phone.
Disable Call Waiting
Disables the call waiting feature. The default setting is "No".
Disable Call Waiting
Tone
Disables the call waiting tone when call waiting is on. The default setting is
"No".
Disable Direct IP Call
Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address. To dial quick IP call,
offhook the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make
direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP
address REGARDLESS of subnet mask. #XX or #X are also valid so leading
0 is not required (but OK). No SIP server is required to make quick IP call.
The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable in-call DTMF
Display
When it's set to "Yes", the DTMF digits entered during the call will not display.
The default setting is "No".
Mute Key Functions
While Idle
When set to “DND”, the DND will be enabled for future incoming call if
pressing MUTE key in idle state; If this feature is set to “Idle Mute”, MUTE key
will take effect in idle state and future incoming call will be answered with
mute; Otherwise, MUTE key will not take effect in idle state.
Disable Transfer
Disables the Transfer function. The default setting is "No".
In-call dial number on
pressing transfer key
Configures the number for the phone to dial as DTMF during the call using
TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape #
as %23 in SIP URI
Specifies whether to replace # by %23or not for some special situations. The
default setting is "No".
Click-To-Dial Feature
Enables Click-To-Dial feature. The default setting is "Disabled".
Call History Flash
Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash. The
default value is 300 seconds.
Call History Flash
Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Settings ->Multicast paging
Paging Barge
During active call if incoming multicast page is higher than this value the call
will be held and multicast page will be played.
Paging Priority Active
If enabled, during a multicast page if another rmulticast is received with higher
priority, that one will be played instead.
Multicast Paging Codec
The codec for sending multicast pages, there are 7 codecs could be used:
PCMU, PCMA, G.723.1, G.726-32, G.729A/B, G.722(wide band), iLBC. The
default setting is “PCMU”. (GXP1628 only)
Multicast Listening
Defines multicast listening addresses and labels. GXP16xx phone can listen
to at most 10 multicast address with different priorities.
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Configures ring or tone frequencies based on parameters from local telecom.
The default value is North American standard.Frequencies should be
configured with known values to avoid uncomfortable high pitch sounds.