Full Product Manual
Table Of Contents
- Before You Spray
- Review Warnings for Important Safety Information
- Related Manuals
- Models
- Online Resources
- Important User Information
- Contents
- Warnings
- Know Your Sprayer
- Know Your Sprayer
- Know Your Sprayer
- Know Your Controls
- Set Up
- Start Up
- Spraying
- Cleanup
- Storage
- Reference
- Maintenance
- Troubleshooting
- Technical Specifications
- Graco Standard Warranty
- Graco Information
Troubleshooting
34 3A6430C EN
Sprayer runs, but pump does not
prime or looses prime while in use.
(Pump cycles but does not pull paint
into Suction Tube or build pressure.)
Prime/Spray Valve is in SPRAY
position.
Turn Prime/Spray Valve down to
PRIME position until paint exits Drain
Tube.
Inlet screen is clogged or Suction
Tube is not completely immersed in
paint.
Clean debris off inlet screen and
make sure Suction Tube is completely
immersed in paint.
Inlet or outlet valve ball is stuck or
dirty.
X5/X7 Only: Press PushPrime button
twice to loosen inlet valve and
reprime sprayer. See Fill Pump
(Prime Pump), page 16.
See Storage/Priming Tool, page 31.
Then reprime pump.
Remove inlet and/or outlet valves and
clean and clean, replace and reprime.
See Fill Pump (Prime Pump), page
16. See figures below:
• Make certain to not lose the
ball and spring of the inlet
valve assembly or the
sprayer will not function.
• Make certain the outlet ball
moves free in the housing
before replacing.
Suction Tube is leaking. Inspect Suction Tube connection for
cracks or vacuum leaks.
Debris in paint causing obstruction. Strain the paint. See Strain the
Paint, page 16.
Prime/Spray Valve is worn or
obstructed with debris.
Take sprayer to Graco/MAGNUM
authorized service center.
Problem Cause Solution