Installation & Assembly

ManualsBrandsGracie Oaks ManualsLightingFayne 1 - Light Dimmable Armed Sconce

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed. However, the

installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box. Carefully unpack your new fixture

and lay out all the parts on a clear area. Take care not to lose any

small parts necessary for installation.

2. Thread the two mounting screws about 1/4” into the pre-drilled holes

in the mounting plate, spaced about the same distance apart as the

holes in the fixture back plate. Attach the mounting plate to the

junction box using two junction box screws as shown. The side of the

mounting plate marked “GND” must face out. The junction box is

not included.

3. Guide fixture wires through hole in center of mounting plate.

4. Follow wiring instructions carefully (see fig.2)

5. Raise the lamp body(D) onto the mounting plate, aligning the holes

with mounting screws, then lock it securely with the ball nuts(E).

Attach the check ring(A) insert to the socket wrench(F), attach the

clear glass(C) and opal glass(B) to the lamp holder, lock them

securely with the socket wrench(F), then remove the socket wrench

and save it.

6. Install the light bulbs(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUN

WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the

junction box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

FIG.1

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.   WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area.