Installations Instructions

4
SAFETY CONSIDERATIONS
Adhere to the following warnings and cautions when install-
ing, adjusting, altering, servicing, or operating the furnace.
To ensure proper installation and operation, thoroughly read
this manual for specifics pertaining to the installation and
application of this product.
This furnace is manufactured for use with natural gas. It
may be field converted to operate on L.P. gas by using the
appropriate L.P. conversion kit listed in the
PROPANE GAS/
HIGH ALTITUDE INSTALLATIONS section of this manual
Install this furnace only in a location and position as speci-
fied in LOCATION REQUIREMENTS & CONSIDERATIONS sec-
tion and INSTALLATION POSITIONS section of this manual.
Provide adequate combustion and ventilation air to the fur-
nace as specified in COMBUSTION & VENTILATION AIR RE-
QUIREMENTS section of this manual.
Combustion products must be discharged to the outdoors.
Connect this furnace to an approved vent system only, as
specified in VENT/ FLUE PIPE & COMBUSTION AIR PIPE sec-
tion of this manual.
Never test for gas leaks with an open flame. Use a commer-
cially available soap solution made specifically for the detec-
tion of leaks to check all connections, as specified in GAS
SUPPLY AND PIPING section of this manual.
Always install a furnace to operate within the furnace’s in-
tended temperature-rise range with a duct system which has
external static pressure within the allowable range, as speci-
fied on the furnace rating plate and OPERATIONAL CHECKS
section of these instructions.
When a furnace is installed so that supply ducts carry air
circulated by the furnace to areas outside the space contain-
ing the furnace, the return air shall also be handled by duct(s)
sealed to the furnace casing and terminating outside the
space containing the furnace.
A gas-fired furnace for installation in a residential garage
must be installed as specified in the LOCATION REQUIRE-
MENTS AND CONSIDERATIONS section of this manual.
This furnace may be used as a construction site heater only
if certain conditions are met. These conditions are listed in
the PRODUCT APPLICATION section of this manual.
FROZEN AND BURST WATER PIPE HAZARD
F
AILURE TO PROTECT AGAINST THE RISK OF FREEZING M AY RESULT IN
PROPERTY DAM AGE .
S PECIAL PRECAUTIONS M UST BE M ADE IF INSTALLING FURNACE IN AN
AREA W HICH M AY DROP BELOW FREEZING . T HIS CAN CAUSE IM PROPER
OPERATION OR DAM AGE TO EQUIPM ENT . I F THE FURNACE
ENVIRONM ENT HAS THE POTENTIAL OF FREEZING , THE DRAIN TRAP AND
DRAIN LINE M UST BE PROTECTED . T HE USE OF ACCESSORY DRAIN TRAP
HEATERS , ELECTRIC HEAT TAPE AND / OR RV ANTIFREEZE IS
RECOM M ENDED FOR THESE INSTALLATIONS .
CAUTION
T O PREVENT PERSONAL INJURY OR DEATH DUE TO IM PROPER
INSTALLATION , ADJUSTM ENT , ALTERATION , SERVICE OR M AINTENANCE ,
REFER TO THIS M ANUAL . F OR ADDITIONAL ASSISTANCE OR
INFORM ATION , CONSULT A QUALIFIED INSTALLER , SERVICER AGENCY OR
THE GAS SUPPLIER .
WARNING
I F THE INFORM ATION IN THESE INSTRUCTIONS IS NOT FOLLOW ED
EXACTLY , A FIRE OR EXPLOSION M AY RESULT CAUSING PROPERTY
DAM AGE
, PERSONAL INJURY OR LOSS OF LIFE .
D O NOT STORE OR USE GASOLINE OR OTHER FLAM M ABLE VAPORS AND
LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE .
D
O NOT TRY TO LIGHT ANY APPLIANCE .
D
O NOT TOUCH ANY ELECTRICAL SW ITCH ; DO NOT USE ANY PHONE
IN YOUR BUILDING .
I
M M EDIATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOR ’ S
PHONE . F OLLOW THE GAS SUPPLIER ’ S INSTRUCTIONS .
I
F YOU CANNOT REACH YOUR GAS SUPPLIER , CALL THE FIRE
DEPARTMENT .
I
NSTALLATION AND SERVICE M UST BE PERFORM ED BY A QUALIFIED
INSTALLER , SERVICE AGENCY OR THE GAS SUPPLIER .
W HAT TO DO IF YOU SM ELL GAS:




WARNING
T HIS PRODUCT CONTAINS OR PRODUCES A CHEM ICAL OR CHEM ICALS
W HICH M AY CAUSE SERIOUS ILLNESS OR DEATH AND W HICH ARE
KNOW N TO THE S TATE OF C ALIFORNIA TO CAUSE CANCER , BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARM .
WARNING
H EATING UNIT SHOULD NOT BE UTILIZED W ITHOUT REASONABLE ,
ROUTINE , INSPECTION , M AINTENANCE AND SUPERVISION . I F THE
BUILDING IN W HICH ANY SUCH DEVICE IS LOCATED W ILL BE VACANT ,
CARE SHOULD BE TAKEN THAT SUCH DEVICE IS ROUTINELY INSPECTED ,
M AINTAINED AND M ONITORED . IN THE EVENT THAT THE BUILDING
M AYBE EXPOSED TO FREEZING TEM PERATURES AND W ILL BE VACANT ,
ALL W ATER - BEARING PIPES SHOULD BE DRAINED , THE BUILDING SHOULD
BE PROPERLY W INTERIZED , AND THE W ATER SOURCE CLOSED . IN THE
EVENT THAT THE BUILDING M AY BE EXPOSED TO FREEZING
TEM PERATURES AND W ILL BE VACANT , ANY HYDRON IC COIL UNITS
SHOULD BE DRAINED AS W ELL AND , IN SUCH CASE , ALTERNATIVE HEAT
SOURCES SHOULD BE UTILIZED .
WARNING
T O PREVENT POSSIBLE PROPERTY DAM AGE , PERSONAL INJURY OR
DEATH DUE TO ELECTRICAL SHOCK , THE FURNACE M UST BE LOCATED TO
PROTECT THE ELECTRICAL COM PONENTS FROM W ATER .
WARNING
Drain trap must be primed at time of installation. Trap is
internally partitioned; add water to both inlet ports until wa-
ter appears at both sides of the outlet opening. Failure to
prime trap at time of installation may have a negative ef-
fect on combustion quality and pressure switch action.