Instructions / Assembly

Extend the track to the width you need (maximum 86”)
2
Mark the screws position with provided screw marker.
Installation video
2.5
Extend the track to the width you need
3
Cut down the cardboard B and use it to mark the central screw point.
Align cardboard A against the left side and mark 2 screw points, vice versa.
4
Attach the track to the mounting brackets.
We recommend additional hand to finish this step.
5
Make sure the mounting brackets are tightened inside the groove.
Caution! All the brackets must be correctly and firmly installed.
Please follow Step 6 to complete the installation.
Note: If you don’t want to use the screw marker, you can also use a tape measure
to draw screw points, 5 screw points must be on the same level.
0.3 in
middle
2 in17 in
2.25 in 2.25 in 2.25 in




2.25 in
2 in 17 in
2.25 in
2.25 in2.25 in
Wall Mount
2.25 in
1.22 in
3.35 in
OUTSIDE MOUNT:
Minimum 2.5” of bracket hight required on the top.
Use a plier and a screw marker to fasten nuts screws.
Lock the middle bracket inside the groove first
and then lock the other 4 brackets.
5
5
5 10
10
16
5
Set Screw
╳
2
Anti fray clip
Before start your installation, please check all pieces.
If there are missing or defective parts, kindly contact GoDear Design directly for further help.
“L” bracket
(for wall mount)