Troubleshooting Motor is not responding Insufficient battery Please refer to the section Checking the battery level. If the battery is low, charge it at least for 2 hours and try again. A full battery charge may take about 6 hours. Cannot pair with remote control Not holding the HEAD button long enough To enter pairing mode, you need to press the button, and keep It pressed, for 3 seconds, until the motor moves. The motor pairing mode lasts 30 seconds.
Getting to know your Neo Curtain Motor Motor shaft Power socket Dry contact LED HEAD button 24V power adapter CM-WRIT and CM-RT models ably Motor installation Choose one of the sides of your track, then insert the motor shaft. Twist the motor 90 degrees counterclockwise, until you hear the latch make a click sound. aS To remove the motor, keep pressed down the latch while you twist and remove the motor. Caution « Motor must be installed in a vertical position and used with curtain tracks.
Dry Contact The dry contact interface offers three control modes, 1 rE Three button control on Hold on ye button rl socket control 8 control Boycott > Interface LED light Setting Three button control mode 43 (Empty) | Action (Open) | on off off * mH > 4(Close) | off on | off I rd a] (Stop) off off Action time must be shorter than 15 Lm = Two button control mode 4321 (Empty) Action K1 K2 4p (Open) on off + Pd(Close) | off on x HM (Stop) | Press any button again 2 rd K2 Hold on control mode 432 1 (Empty) Acti
Pairing process Up to 16 channels can be stored on the motor. Using a Neo Remote Control All our Nea Remote Controls RC200 series work with the motor, 1. Using the remote control, ea press the CHANNEL button @) as many times needed to o select the desired channel to pair the motor. RC215, RC230 Press the PREVIOUS CHANNEL or the NEXT CHANNEL buttons Instead. 2. Hold the HEAD button for 3 seconds, until the motor moves. 3.
