Owners manual

INSTALLATION INSTRUCTIONS

RB10 SIDE STEPS

TOYOTA TACOMA DOUBLE CAB

TOYOTA TACOMA DOUBLE CAB TOYOTA TACOMA DOUBLE CAB

TOYOTA TACOMA DOUBLE CAB

63442987T

2005 - 2015

Parts list

Iten QTY Códe Description Max Torque

1 1 set 630087T Side steps

2 1 set 6344294AA Front Bracket

3 2 sets 6344294BA Center and Rear bracket

4 6 piece 6300874AA U-bracket

5 12 piece 5/16” x 1” hex head bolt black plate 11 Lb. Ft.

6 12 piece 5/16” flat washer black plate

12 piece 5/16” lock washer black plate

8 12 piece M8 x 25mm hex heat bolt zinc plate 25 Lb. Ft.

9 12 piece 5/16” flat washer zinc plate

10 12 piece 5/16” lock washer zinc plate

Required Tools (Not included)

Ratchet

w/ extension

B. 12 mm socket

C. 13 mm socket

D. 15 mm socket

1.- Before beginning the installation, please read all directions carefully and verify that all necessary hardware is

accounted for. If any parts are missing,

stop the installation and contact your distributor immediately.

2.- To maintain and care this product keep it clean and do not use abrasive cleaners or polish waxes. We

recommend to use only non-abrasive

automotive wax such as pure carnauba to avoid scratches and rust.

3.- The approximate installation time is 35 min.

R&D QA FOD17.003.E PAGE: 1/3

PAGE 1
INSTALLATION INSTRUCTIONS RB10 SIDE STEPS TOYOTA TACOMA DOUBLE CAB 63442987T 2005 - 2015 Parts list Iten QTY Códe Description Max Torque 1 1 set 630087T Side steps 2 1 set 6344294AA Front Bracket 3 2 sets 6344294BA Center and Rear bracket 4 6 piece 6300874AA U-bracket 5 12 piece 5/16” x 1” hex head bolt black plate 6 12 piece 5/16” flat washer black plate 7 12 piece 5/16” lock washer black plate 8 12 piece M8 x 25mm hex heat bolt zinc plate 9 12 piece 5/16” flat washe
PAGE 2
1. Before beginning the installation read all instructions carefully and verify that all hardware is accounted for. if there are any listed parts missing, please notify your distributor immediately. 4. To install middle and rear brackets use two M8x30 hex head galvanized bolts, two flat washers and two lock washer for each bracket. See Picture 4 and repeat it in the opposite side. Leave loose. 2. See pictures 1, 2 Y 3 and locate the holes where the brackets are going to be installed. Pict. 1 Pict.
PAGE 3
7. Place the sidebar on top of the mounting brackets. Position (3) of the U-brackets (included with the side step) inside the sidebar body, and align the U-brackets with the mounting brackets. Attach the side step and U-brackets to each mounting brackets using (2) 5/16" Hex head bolts, (2) 5/16" flat washers and (2) 5/16" lock washers. ILLUSTRATION 1. Pict.6 ILLUSTRATION 1 U-bracket 8. Align side bar RB10 and then tighten all bolts. 9.