User's Manual

GO MBW Getting Started Guide
GO MBW Getting Started GuideGO MBW Getting Started Guide
GO MBW Getting Started Guide
Draft Version - Confidential - Page 24
The order in which the cables should be connected is as follows:
• Grounding Cable
• Ethernet Cable
• Power Cable
Grounding Cable
Note: The grounding cable should be connected to the grounding
screw. For the grounding cable, you should use a 1mm /
18awg. You should connect the grounding cables before any
other connections.
Noter: Le câble de la masse doit être connecte au visse de la masse.
Pour le câble de la masse vous devez utiliser un 1mm /
18awg. Vous devez connecter le câble de la masse avant tout
autre connexion.
Ethernet Cable Connection
Following is a diagram explaining how the Ethernet cable should be assembled prior
to connecting it to the WLS unit:
Ethernet Cable Connector
The Ethernet cable should be connected to an Ethernet switch, ADSL or cable
modem, according to the site installation requirements. The outer diameter of the
Ethernet cable should be 4.8 – 7 mm.
In an outdoor installation, the Ethernet cable should be connected to a lightning
protector. The lightning protector is then connected to the Ethernet switch, ADSL or
cable modem. GO MBW recommends the GO MBW WLAN Sector Base-Station-3001,
(a weather-proof, point-of-entry, 10/100 Base-T CAT5 Lightning Protector), which
can be ordered as an optional accessory of the GO-MBW package.