Assembly Instruction 5 SHELF BOOKCASE
PRE-ASSEMBLY PREPARATION • CAUTION: Assembly will require at least 2 adults. DO NOT use power tools. Please inspect all items BEFORE assembly. If for any reason you need to return this item, please kindly return it in it's original packaging. • WARNING! 1. DO NOT let any sharp objects touch or rub the surface of the product. 2. When assembling, do not let children play around the working area. 3. DO NOT tighten all bolts and screws completely until the entire unit has been assembled and set up. 4.
PARTS LIST SHELF PANEL (A) TOP PANEL (B) Qty: 4 LEFT BOTTOM PANEL (E) SHELF CROSS BAR (C) Qty: 1 RIGHT UPPER FRAME (F) Qty: 1 LEFT UPPER FRAME (D) Qty: 5 RIGHT BOTTOM FRAME (G) Qty: 1 REAR CROSS BAR (H) Qty: 1 Qty: 1 Qty: 4 HARDWARE LIST ALLEN BOLT (1) ALLEN BOLT (2) ALLEN BOLT (3) ALLEN BOLT (4) M6*12mm M6*22mm M6*28mm M5*15mm Qty: 9 Qty: 10 Qty: 10 PHILLIPS SCREW (5) NUT (6) ALLEN WRENCH (7) 4*12mm M5 4mm Qty: 4 Qty: 1 Qty: 1 OPEN END WRENCH (8) Qty: 1 Qty: 1 L STEEL PLAT
REQUIRED HARDWARE IN THIS STEP NO. DESCRIPTION 1 ALLEN BOLT M6*12mm 8PCS 7 ALLEN WRENCH 1PC STEP 1 SKETCH QTY Assemble left upper frame (D) on left bottom frame (E) with Allen bolts (1) by using Allen wrench (7). Repeat this action for F & G. D F E 1 1 These 4 holes must be one side D 1 1 D 1 These 4 holes must be one side E G 1 E REQUIRED HARDWARE IN THIS STEP NO.
REQUIRED HARDWARE IN THIS STEP STEP 3 NO. DESCRIPTION SKETCH QTY 4 ALLEN BOLT M5*15MM 1PC 6 NUT M5 1PC 7 ALLEN WRENCH 1PC 8 OPEN END WRENCH 1PC Assemble all rear cross bars (F) together at one end with Allen bolts (4) and nut (6) using Allen wrench (7) and Open end wrench (8). Fully tighten in this step. H H 6 H 4 H REQUIRED HARDWARE IN THIS STEP STEP 4 NO.
REQUIRED HARDWARE IN THIS STEP STEP 5 NO. DESCRIPTION SKETCH QTY 3 ALLEN BOLT M6*30MM 10PCS 7 ALLEN WRENCH 1PC Assemble top panel (B) & shelf panel (A) on ready metal frame with Allen bolts (3) by using Allen wrench (7). B A The hole on top panel (B) should be on the bottom and same side as x steel wire (F). 3 A 3 A 3 3 A 3 3 3 3 3 3 REQUIRED HARDWARE IN THIS STEP STEP 6 NO.
REQUIRED HARDWARE IN THIS STEP NO. DESCRIPTION 9 STEEL PLATE 1PC 10 ANTI-TIPPING STRIP 1PC 11 WALL ANCHOR Ø8.5*30MM 1PC 12 SCREW M4*25MM 1PC STEP 7 SKETCH QTY Drill one hole on the wall and then put wall anchor (11) into the pre-drilled hole. Assemble steel plate (9) to the wall with screw (12) using screwdriver. Attach anti-tipping strip (10) to the steel plate (9) as shown.
