COOKER HOOD INSTRUCTION MANUAL AND INSTALLATION GUIDE Please read this guide before installing and using the hood MODEL DESCRIPTION CK90TBTF CK120TBTF 90cm T shape canopy 120cm T shape canopy �EMILIA if GLEM Emilia Glem Appliances 48 Percy Street Auburn NSW 2144 PO BOX 63 Blaxcell PO South Gran ville NSW 2142 Tel 02 9721 2755 Fax 02 9721 2766 www.glemgas.com.
Product Specification & Technical Parameters Model CK90TBTF/CK120TBTF Rated Voltage 230V Rated Power Frequency 50Hz Light Power 1x4W MAX Motor Power 230W Total Power 234W Motor Single Diameter of Outlet Adapter 150mm Dimension (mm) W900/1200 X D500 X H570min/1050max RECOMMENDATIONS AND SUGGESTIONS INSTALLATION * The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
USE * The range hood has been designed only for domestic use to eliminate kitchen fumes. * Never use the hood for purposes other than what it has not been designed for. * Never leave high naked flames under the hood when it is in operation. * Adjust the flame intensity to direct it onto the bottom of the pan only; making sure that it does not engulf the pan sides. * Deep fat fryer must be continuously monitored during use: overheated oil can burst into flame.
* TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. b) Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting.
INSTALLATION & USE OPERATION OF CONTROLS low mid ｂｏｏｓｔ ｅｒ light on/off The hood is operated using the touch control. The on/off switch turns the hood on and off. The light switch turns the lamps on and off. The blower switch turns the blower on to three speed settings: 1 - LOW SPEED 2 - MEDIUM SPEED 3 - BOOSTER Grease Filters The grease filters should be cleaned frequently. Use a warm detergent solution. Grease filters are washable.
ductwork sections. INSTALL ELECTRICAL Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards. This range hood must be properly grounded. Turn off electrical power at service entrance before wiring. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
5. 6. 7. 8. chimney bottom. Carefully place the decorative chimney bottom into the recessed area of the hood body top. Secure the chimney mounting bracket to the wall using (2) ST 2.9 x 4 mounting screws and dry wall anchors. 14mm Raise the decorative chimney top until its holes align with holes in the chimney mounting bracket (located on the wall). Level the hood and secure the chimney with 2 chimney bracket screws.
(2) Filter 3．To install the charcoal filter (optional), and lock it until the stop click is heard. 7、 Optional (2) M4*12 4. Install grease filter after charcoal filter is installed.
