SDS

ManualsBrandsGlaze 'N Seal ManualsBuilding materials1 gal. Concrete Low Gloss Matte Floor Polish

SAFETY DATA SHEET

Matte Floor Polish

Prepared to U.S. OSHA, CMA, ANSI, Canadian WHMIS Standards, and European Directives

SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION

1.1 Trade Name (as labeled):

Matte Floor Polish

IDH #: 450

Synonyms: Waterbourne Acrylic Emulsion Floor Finish

CAS No: Mixture

1.2 Product Use:

Institutional Floor Polish

1.3 Company Name: Glaze ‘N Seal Products Inc.

Company Address: 18207 E. McDurmott Street Suite C

Company Address Cont: Irvine, CA 92614-6711

Business Phone: (800) 486-1414

Website: http://glaze-n-seal.com

1.4 Emergency Telephone Number: (800) 424-9300

Date of Current Revision: May 11, 2017

Date of Last Revision: May 3, 2017

SECTION 2 - HAZARD IDENTIFICATION

EMERGENCY OVERVIEW: This product a white liquid with a sweet odor.

Health Hazards: Contact with the skin and eyes may cause irritation.

Flammability Hazards: This product is nonflammable.

Reactivity Hazards: None.

Environmental Hazards: The environmental effects of this product have not been investigated, however release may cause long term

adverse environmental effects.

US DOT Symbols:

Not Regulated

EU and GHS Symbols:

None

Signal Word: Not Applicable

2.1 GHS Labeling and Classification:

CLASSIFICATION OF SUBSTANCE OR MIXTURE IN ACCORDANCE WITH 29 CFR 1200 (OSHA HCS) AND THE

EUROPEAN UNION DIRECTIVES:

This product does meet the definition of a hazardous substance or preparation as defined by the European Union Council Directives

67/548/EEC, 1999/45/EC, 1272/2008/EC and subsequent Directives.

EU HAZARD CLASSIFICATION OF INGREDIENTS PER DIRECTIVE 1272/2008/EC:

EC# 203-919-7 is not listed under Annex VI

EC# 201-122-9 is not listed under Annex VI

Substances not listed either individually or in group entries must be self classified.

Components Contributing to Classification:

Tributoxyethyl Phosphate, Diethylene Glycol Monoethyl Ether

2.2 Label Elements:

GHS Hazard Classifications:

Skin Irritation Category 3

Eye Irritation Category 2B

Hazard Statements:

H316 Causes skin irritation

H320 Causes eye irritation

Prevention Statements:

P264 Wash thoroughly after handling

Response Statements:

P332+P313 If skin irritation occurs: Get medical advice/attention.

P305+P351+P338 IF IN EYES: Rinse cautiously with water for several

minutes. Remove contact lenses, if present and easy to do. Continue rinsing.

P337+P313 If eye irritation persists: Get medical advice/attention.

Storage Statements:

None Applicable

Disposal Statements:

None Applicable

Summary of content (7 pages)

PAGE 1
SAFETY DATA SHEET Matte Floor Polish Prepared to U.S. OSHA, CMA, ANSI, Canadian WHMIS Standards, and European Directives SECTION 1 - PRODUCT AND COMPANY IDENTIFICATION 1.1 Trade Name (as labeled): Matte Floor Polish IDH #: Synonyms: CAS No: 1.2 Product Use: 1.3 Company Name: 450 Waterbourne Acrylic Emulsion Floor Finish Mixture Institutional Floor Polish Glaze ‘N Seal Products Inc. Company Address: Company Address Cont: Business Phone: Website: 1.4 Emergency Telephone Number: 18207 E.
PAGE 2
Matte Floor Polish Glaze ‘N Seal 2.3 Health Hazards or Risks From Exposure: Symptoms of Overexposure by Route of Exposure: The most significant routes of overexposure for this product are by contact with skin or eyes. The symptoms of overexposure are described in the following paragraphs. Acute: Inhalation: None expected under normal conditions. Skin Contact: Prolonged or repeated skin contact may cause irritation. Eye Contact: May cause eye irritation. Ingestion: None expected under normal conditions.
PAGE 3
Matte Floor Polish Glaze ‘N Seal  Incipient fire responders should wear eye protection.  Structural firefighters must wear Self-Contained Breathing Apparatus (SCBA) and full protective equipment.  Isolate materials not yet involved in the fire and protect personnel. Move containers from fire area if this can be done without risk; otherwise, cool with carefully applied water spray.  If possible, prevent run-off water from entering storm drains, bodies of water, or other environmentally sensitive areas.
PAGE 4
Matte Floor Polish Glaze ‘N Seal SECTION 8 - EXPOSURE CONTROL/PERSONAL PROTECTION 8.1 Exposure Parameters: Ingredients Diethylene Glycol Monoethyl Ether Tributoxyethyl Phosphate CAS No. ACGIH TLV OSHA PEL NIOSH PEL 111-90-0 Not Listed Not Listed Not Listed 78-51-3 Not Listed Not Listed Not Listed 8.2 Exposure Controls: Ventilation and Engineering Controls: Use with adequate ventilation to ensure exposure levels are maintained below the limits provided above.
PAGE 5
Matte Floor Polish Glaze ‘N Seal Partition Coefficient (n-octanol/water): No data available Auto-Ignition Temperature: No data available Decomposition Temperature: No data available Viscosity: <10 cps VOC: <1% by weight 9.2 Other Information: No data available SECTION 10 - STABILITY AND REACTIVITY 10.1 Reactivity: 10.2 Stability: 10.3 Possibility of Hazardous Reactions: 10.4 Conditions to Avoid: 10.5 Incompatible Substances: 10.6 Hazardous Decomposition Products: This product is not reactive.
PAGE 6
Matte Floor Polish Glaze ‘N Seal North American Emergency Response Guidebook Number: N/A Note: None. 14.2 Environmental Hazards: Marine Pollutant: 14.3 Special Precaution for User: 14.4 International Air Transport Association Shipping Information (IATA): 14.5 International Maritime Organization Shipping Information (IMO): The components of this product are not designated by the Department of Transportation to be Marine Pollutants (49 CFR 172.101, Appendix B).
PAGE 7
Matte Floor Polish Glaze ‘N Seal 15.5 Japanese Information for Product: Japanese Minister of International Trade and Industry (MITI) Status: The components of this product are not listed as Class I specified Chemical Substances, Class II Specified Chemical Substances, or Designated Chemical Substances by the Japanese MITI. 15.