Installation Guide

1
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Phillips
screwdriver
Claw
hammer
USE AND CARE GUIDE
TOWEL BAR
TOOLS REQUIRED
Electric drill
TemplateLevel Masking Tape
HARDWARE INCLUDED
Item #1006831829
1006831132
Model #BTH-018-225-BG
BTH-024-226-BG
A- Self-drilling
drywall anchor
x4
B- Mounting bracket
x2
C- Mounting screw
x4
D- Hex wrench
x1
E- Set screw
x2
F- Solid wall anchor
x4
Determining the mounting
location
Installing the bracket in
drywall
1 3.1
Tape the template to the wall with masking
tape and ensure it is completely level
Use a level to determine the location where
you want to install your accessory.
Drilling the pilot hole
2
Pre-drill a pilot hole with a small drill
Safety Information
If installing into ceramic tile, before attempt-
ing to drill through ceramic tile, the following
must be done:
Using a center punch, very lightly and
carefully tap the spot where you wish to drill
to break the shiny glass portion of the tile.
Drill a 1/8 in. based on the pre-drill pilot hole.
Drive the drywall anchor (A) into the wall using
a Phillips screwdriver until flush with the wall.
Align the mounting brackets (B) with the
drywall anchor (A) and secure with the
mounting screws (C).
Installing the bracket in
wood stud
Drill 3/32 in. based on pre-drilled pilot hole.
Align the mounting brackets (B) with pilot
holes and secure with the mounting screws
(C).
NOTE: To install the brackets (B) in a wood
stud, proceed to Step 3.2. To install the
brackets (B) in ceramic tile, proceed to Step 3.3.
Installation
3.2
A
B
C
B
C