Installation Guide

1
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Phillips
screwdriver
Claw
hammer
USE AND CARE GUIDE
TOWEL BAR
TOOLS REQUIRED
Electric drill
TemplateLevel Masking Tape
HARDWARE INCLUDED
Item #100-483-3710
100-483-3715
Model #BTH-018-107
BTH-024-108
B- Mounting bracket
x2
C- Mounting screw
x4
D- Hex wrench
x1
E- Set screw
x2
F- Solid wall anchor
x4
Determining the mounting
location
Installing the bracket in
drywall
1 3.1
Tape the template to the wall with masking
tape and ensure it is completely level
Use a level to determine the location where
you want to install your accessory.
Drilling the pilot hole
2
Pre-drill a pilot hole with a small drill
Safety Information
If installing into ceramic tile, before attempt-
ing to drill through ceramic tile, the following
must be done:
Using a center punch, very lightly and
carefully tap the spot where you wish to drill
to break the shiny glass portion of the tile.
Drill a 1/8 in. based on the pre-drill pilot hole.
Drive the drywall anchor (A) into the wall using
a Phillips screwdriver until ush with the wall.
Align the mounting brackets (B) with the
drywall anchor (A) and secure with the
mounting screws (C).
Installing the bracket in
wood stud
Drill 3/32 in. based on pre-drilled pilot hole.
Align the mounting brackets (B) with pilot
holes and secure with the mounting screws
(C).
NOTE: To install the brackets (B) in a wood
stud, proceed to Step 3.2. To install the
brackets (B) in ceramic tile, proceed to Step 3.3.
Installation
3.2
A
B
C
B
C
A- Self-drilling
drywall anchor
x4