Installation Guide

ManualsBrandsGlacier Bay ManualsFarmhouse Kitchen SinksRetrofit Drop-In Stainless Steel 33 in. 2-Hole 50/50 Double Bowl Curved Farmhouse Apron Front Kitchen Sink

For Top-Mount Use Only

Tools Needed

For Under-Mount Installation please refer to page 14

-1-

Disclaimer: Undermount Application must useamodified sink base and solid surface countertop material.

The countertop must be flat. This sink will not install to countertops with integral drip edges.

*Your countertop thickness cannot exceed 1-1/2" (38 mm).

*Your countertop cannot overhang the cabinet face more than 1-1/2" (38 mm).

*Your countertop must be fully supported by the cabinet.

*Proper installation requiresacoordinated effort including advanced dialog between the

designer (or customer), the cabinet maker, the countertop fabricator and the sink installer

during the design and installation phase.

FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY

This installation project is designed for an advanced skill level.

IMPORTANT!

*BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL A DAMAGED UNIT.

CAUTION:

Risk of personal injury. Metal surfaces are sharp and can cause severe cuts. Please use gloves and

handle sink with care.

* These instructions provide2different installation methods: new countertop installation and replacement.

Follow the instructions that apply to your installation method.

* Inspect the drain and supply lines; replace if necessary.

* Remember it is your responsibility to follow all local plumbing and building codes.

The warranty wil

l be voided i f these installation instructions are not followed.

Silicone Sealant

Tape Measure

Safety Glasses

Painter's Tape

Felt-tip Marker

Laminate Jigsaw Blade

Scissors Saw

Sandpaper

Utility Knife

Level

Flat Screwdriver

Square

Hand Saw

Foam-Brush

Waterproof Wood Glue

210 mm

mm 582

Retrofit Apron Front Farm Sink

With Dual Mount Capability

Installation Instructions

Haveaquestion? DON'T GO BACK TO THE STORE, WE CAN HELP, just call 1-855-434-5224（1-855-HD-Glacier）

Summary of content (16 pages)

PAGE 1
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only For Under-Mount Installation please refer to page 14 FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY This installation project is designed for an advanced skill level. Disclaimer: Undermount Application must use a modified sink base and solid surface countertop material. IMPORTANT! The countertop must be flat. This sink will not install to countertops with integral drip edges.
PAGE 2
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only Before You Start Please complete this check list. This sheet is designed to assist you in making an informed decision on the selection of your retrofit apron front farm sink. Please answer the following questions to determine whether your current kitchen cabinet can use this style of sink. 1) Is your countertop flat? The countertop must be flat to assure a proper installation.
PAGE 3
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 4) Is the dimension between the cabinet stiles 33"? This measurement is the open space from left to right when the false drawer front is removed. Typically, this distance can be measured from the inside of the cabinet without removing the false drawer fronts. YES NO 5) Measure the distance from the top of the door rail to the top of the cabinet.
PAGE 4
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 1. Prepare the Cabinet - Replacement of an Existing Sink - Please remove the false fronts (two small or one large panel) please be careful not to damage the cabinet front. - Apply painter's tape to the cabinet front, this will help prevent damaging the surface when cutting out the drawer fronts.
PAGE 5
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 3. Trace the Template - Cut out the paper template along the top mount marked line. - Cut out the diamond on the template; this will help you line up the centerline; it should be in the center of the diamond. - Please put painter's tape to all exposed outside edges prior to securing the template in place. This will help prevent chipping when cutting. - Put the template on the countertop.
PAGE 6
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 4. Cut the Countertop IMPORTANT! To avoid damage to the cabinet surfaces, cut the countertop in the order of the steps below. Note: If your existing sink hole is set back close to the backsplash you will need to adjust the depth of the notch.This will allow you to slide the sink back further to get a tight fit. Do not cut beyond marked line! 2. Cut away from cutout, flush with cabinet face.
PAGE 7
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 5. Install the Sink - To protect the cabinet finish, temporarily apply painter's tape around the cabinet cutout. - Apply a bead of silicone around the cutout. - Carefully lower the sink into the cabinet. - Be sure to wipe away any excess silicone sealant. 6. Install the clips from under the cabinet. - Slide three clips into either side of the back rail of the sink.
PAGE 8
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 7. Finishing the Installation - Apply silicone sealant around the edge of the sink, be sure to completely cover the notched area where the countertop meets the apron front sink. - Wipe away excess before it dries. - Install the faucet and drain per manufacturer's installation instructions. Note: To add a finishing touch to your new sink you can add a furring strip around the apron.
PAGE 9
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 1. Prepare the cabinet - New Countertop Installation - Please remove the false fronts (two small or one large panel) please be careful not to damage the cabinet front. - Apply painter's tape to the cabinet front, this will help prevent damaging the surface when cutting out the drawer fronts.
PAGE 10
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only Countertop Overhang 3. Preparing Your Countertop - Put the painter's tape at the centerline of the cabinet from the backsplash to the front edge of the countertop. - Put the painter's tape across the front edge of the countertop along the entire width of the sink base cabinet. Center line Front of Cabinet - Mark the centerline of the cabinet onto the painter's tape. 4.
PAGE 11
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 5. Cut the Countertop IMPORTANT! To avoid damage to the cabinet surfaces, cut the countertop in the order of the steps below. TIP: To prevent chipping the laminate, put painter's tape to the edge of the countertop before cutting. TIP: Make sure your equipment is in good working order and your blades are sharp to ensure a smooth installation and straight cuts. Do not cut beyond marked line! 2.
PAGE 12
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 6. Install the Sink - To protect the cabinet finish, temporarily put painter's tape around the cabinet cutout. - Apply a bead of silicone around the cutout. - Carefully lower the sink into the cabinet. - Be sure to wipe away any excess silicone sealant. 7. Install the clips from under the cabinet - Slide three clips into either side of the back rail of the sink.
PAGE 13
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Top-Mount Use Only 8. Finishing the Installation - Apply silicone sealant around the edge of the sink, be sure to completely cover the notched area where the countertop meets the apron front sink. - Wipe away excess before it dries. - Install the faucet and drain per the manufacturer’s installation instructions.
PAGE 14
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Under-Mount Use Only Under-counter Mount Instructions Caution: For Reference, Read All Instructions Before Beginning The Installation. Before You Begin Metal edges may be sharp use caution when handling. For Experienced and Professional Installation only. Follow all local standards and codes. For solid surface countertop installations only ie: granite, quartz, stone etc. A custom sink base cabinet is required.
PAGE 15
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions For Under-Mount Use Only Step 4. Countertop Step 5. Fasteners Screws Using the mounting screws, fasten the mounting brackets to the countertop loosely. The brackets need to be loose enough to slide under the rim of the sink. Using a good quality silicone sealant, apply a bead evenly around the entire sink rim. Step 6. Position and align the sink under the countertop opening.
PAGE 16
Retrofit Apron Front Farm Sink With Dual Mount Capability Installation Instructions LlMITED LlFETIME WARRANTY The manufacturer warrants that the parts and assemblies of this product will be free from defects in material and workmanship under normal household use for as long as it is owned by the original consumer purchaser. This warranty covers the original consumer purchaser only and does not include business, commercial or industrial use of this product.