Instructions / Assembly

Page 1 of 307/28/21

Customer Service: 847-821-9646

4-ARM TREE

BASKET STAND

31.5”L x 29”W x 72.75”H

HB4T-A USER MANUAL

Parts Description Quantity

A Bottom Section 4

B1 Middle Section 2

B2 Middle Section 2

C Top Section 1

D Top Section 1

E Top Section 1

F Top Section 1

G Ground Peg 4

H Screw with Wing Nut 3

J Metal Screw 8

K End Cap 8

Parts Description Quantity

L Hook 4

M Hanging Basket 4

N Liner 4

Assembly - Tools required: Phillips Screwdriver.

Please check enclosed parts shipped with this product. If any parts are missing, do not return the item to the retailer.

Please contact us for replacement parts by calling Customer Service at 847-821-9646.

• This unit is heavy when planted and must be

positioned on a hard level surface, away from

children and vulnerable adults.

• Only suitable for use with baskets up to 12 inch

diameter.

• Please read and follow all instructions before

assembling or using this product.

This pack contains small items which should be

kept away from children.

IMPORTANT SAFETY NOTICE

CAUTION

PAGE 1
31.5”L x 29”W x 72.75”H 4-ARM TREE BASKET STAND HB4T-A USER MANUAL Assembly - Tools required: Phillips Screwdriver. Please check enclosed parts shipped with this product. If any parts are missing, do not return the item to the retailer. Please contact us for replacement parts by calling Customer Service at 847-821-9646.
PAGE 2
Assembly 1 Assembly 2 Bottom Section (A), Middle Sections (B2), Top Sections (F) using Metal Screws (J). Add End Caps (K) to Bottom Section (A) amd Top Section (F). Bottom Section (A), Middle Sections (B1), Top Sections (E) using Metal Screws (J). Add End Caps (K) to Bottom Section (A) and Top Section (E). F K K E J B2 B1 J A Typical Section Assembly Typical Section Assembly K A K Assembly 3 Assembly 4 Bottom Section (A), Middle Sections (B1), Top Sections (D) using Metal Screws (J).
PAGE 3
Assembly 5 Assembly 4 Assembly 3 Assembly 5 for four previously assemblies using Screw with Wing Nuts (H). Hint: Lay on a flat surface. Start with Assembly 1 with curved sections facing to the right. Next, place the Assembly 2 to the left of Assembly 1 with the curved sections facing down. Next, place Assembly 3 to the left of Assembly 2 with the curved sections facing up. Next, place Assembly 4 to the left of Assembly 3 with the curved sections facing to the left.