Datasheet

- 59 - BIOS Setup

2-12 Set Supervisor/User Password

` Standard CMOS Features

` Advanced BIOS Features

` Integrated Peripherals

` Power Management Setup

` PnP/PCI Configurations

` PC Health Status

` MB Intelligent Tweaker(M.I.T.)

ESC: Quit KLJI: Select Item F11: Save CMOS to BIOS

F8: Q-Flash F10: Save & Exit Setup F12: Load CMOS from BIOS

Change/Set/Disable Password

Load Fail-Safe Defaults

Load Optimized Defaults

Set Supervisor Password

Set User Password

Save & Exit Setup

Exit Without Saving

Enter Password:

Press <Enter> on this item and type the password with up to 8 characters and then press <Enter>. You

will be requested to confirm the password. Type the password again and press <Enter>.

The BIOS Setup program allows you to specify two separate passwords:

Supervisor Password

When a system password is set and the Password Check item in Advanced BIOS Features is

set to Setup, you must enter the supervisor password for entering BIOS Setup and making BIOS

changes.

When the Password Check item is set to System, you must enter the supervisor password (or

user password) at system startup and when entering BIOS Setup.

User Password

When the Password Check item is set to System, you must enter the supervisor password (or

user password) at system startup to continue system boot. In BIOS Setup, you must enter the

supervisor password if you wish to make changes to BIOS settings. The user password only

allows you to view the BIOS settings but not to make changes.

To clear the password, press <Enter> on the password item and when requested for the password,

press <Enter> again. The message "PASSWORD DISABLED" will appear, indicating the password has

been cancelled.