Owner's Manual

Appendix- 85 -

In the following procedure, we'll create RAID 0 as an example.

1. Under the RAID Mode section, press the <SPACE> key to select RAID 0.

2. Set the Stripe Block size. 64 KB is the default.

3. Under the Drives Assignments section, press the up or down arrow key to highlight a drive.

4. Press the <SPACE> key or <Y>to change the Assignment option to Y. This action adds the drive

to the disk array. The Total Drv section will show the number of disks assigned.

5. Press <Ctrl>+<Y> keys to save the information. The window below will appear.

View Drive Assignments

The View Drive Assignments option in the Main Menu displays whether the attached hard drives are

assigned to a disk array or are unassigned. Under the Assignment column, drives are labeled with

their assigned disk array or shown as Free if unassigned.

Figure 7

Figure 8

6. Press <Ctrl>+<Y> to clear the MBR or press other keys to ignore this option. Then, the window

below will appear.

Fast Initialization option has been selected

It will erase the MBR data of the disk.

Figure 6

7. Press <Ctrl>+<Y> to set the capacity of the RAID array or press other keys to set the array to its

maximum capacity.

8. After the creation is complete, the screen will return to Define LD Menu where you will see the

newly-created array.

9. Press <Esc> to return to Main Menu and press <Esc> again if you want to exit the RAID BIOS

utility.

Press Ctrl-Y to Modify Array Capacity or press any

other key to use maximum capacity...

[ ] Up [] Down [ESC] Exit [Ctrl+H] Secure Erase [PgUp/Dn] Page Change

[ Keys Available ]

[ View Drives Assignments ]

Channel:ID Drive Model Capabilities Capacity (GB) Assignment

1:Mas WDC WD800JD-22LSA0 SATA 3G 79.89

Extent 1 79.82 LD 1-1

2:Mas WDC WD800JD-22LSA0 SATA 3G 80.2

Extent 1 80.02 LD 1-2