Installation Guide

Install L-Hangers for additional bottom support
on 4'x6', 4'x8', 4'x10', and 4'x12' sizes.
(Position all L-Hangers 6" from end of board)
GUIDE
GROOVE
Board Mounting Hole
(Mark for pre-drilling)
Position
screw in
the center
of slot
Board Hanging Instructions
Note: This installation guide is used for boards of
different sizes, both with and without accessory trays.
Due to the variances, you may receive more hanging
hardware than required for your board. Please be sure
to read all instructions before installing your
whiteboard.
STEP 1 :
Align the tray end caps with each end of the tray and firmly
push them onto the accessory tray. See Illustration 1.
STEP 2 (Without Tray):
Determine the desired height from the
floor to the bottom of the board. Scribe a level line on the wall at that
distance. Position the bottom of two L-hangers along the scribed line.
The L-hangers should be positioned 6" from the edge of your board.
Scribe the location of the slot. Fasten the L-hangers tightly to the wall
using the appropriate hardware for the mounting surface.
STEP 2 (With Tray):
Determine the desired height from the floor to
the bottom of the board. Scribe a level line on the wall at that distance.
Position the bottom edge of the accessory tray along this line. Using the
groove at the rear of the accessory tray as a guide, pre-drill 1/8"
diameter holes through the accessory tray. Fasten the accessory tray to
the wall using the appropriate hardware for the mounting surface. See
Illustration 2.
STEP 3:
Lift and center the board on the mounted accessory tray / L-
hangers. Scribe a line on the wall along the top edge of the board.
Remove the board and position the top edge of two L-hangers along this
line 6" from the edge of the board.
NOTE: Place each screw in the center of each L-hanger's slot.
Fasten each L-hanger to the wall using the appropriate hardware for the
mounting surface. Be sure not to over tighten the top L-hangers, as this
may affect Step 4. See Illustration 3.
STEP 4:
Tap the L-hangers up until the screw is resting in the lower
end of the hanger's slot. Place the board onto the accessory tray / L-
hangers and tap the top L-hangers down against the frame. Using the L-
hangers as a template, mark all the board mounting hole locations
(including lower L-hangers if used). Remove the board. Drill 1/8"
diameter holes at each of the marked locations and reattach the board
with the #8 x 1/2" screws provided. See Illustration 4.
For more information or to access the installation
videos, please visit our website at
www.ghent.com/install
WWW.GHENT.COM - LEBANON, OH - 800-543-0550 IS-2010AL 08/21



1
2
34