Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box. Carefully unpack your new fixture
and lay out all the parts on a clear area. Take care not to lose any
small parts necessary for installation.
3. Guide fixture wires through hole in center of mounting plate. Follow
wiring instructions carefully (see fig.2).
4. Attach the back plate of the lamp body onto the junction box,
aligning the back plate’s hole with mounting screw and lock it
securely with the ball nuts.
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from
the fixture to the black house (hot) Wire. Connect the white wire from
the fixture to the white (neutral) house wire. Make sure all wire nuts
are secured. You may wrap the connections with electrical tape. If
your outlet box has a ground wires (green or bare copper) connect
fixture’s ground wire to it. Otherwise attach the bare copper fixture
wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
Mountingplate
Mounting
Ground
JunctionBox
(Notincluded)
wire
screw
Fixture
Wire
Lampbody
Ballnut
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
©COPYRIGHT ALL RIGHTS RESERVED.
FIG.2
FIG.1
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service
5. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
2. Thread the two mounting screws about 1/4” into the pre-drilled holes
in the mounting plate, spaced about the same distance apart as the
holes in the fixture back plate. Attach the mounting plate to the
junction box using two junction box screws as shown. The side of
the single bar marked “GND” must face out. The junction box is
not included.